Welcome to Asian creation communication co.,ltd
Professional Antenna Manufacturer & ODM/OEM Supplier
Base Station, FPV & Anti-UAV, Directional & Omni Antennas
service hotline
+86 757-87668779
+86 13925901402
Home
About us
Company Introduction
Profile
OEM/R&D
Certification
Production Line/Equipment
Quality Control
Packing
Purchse Guide
Products
Combination Antennas
5G/CBRS Antennas
4G/LTE Antennas
MIMO Antennas
4.9-6.4GHz Antennas
3.3-3.8GHz Antennas
2.3-2.7GHz Antennas
800-2100MHz Antennas
GSM/UMTS Antennas
RFID Antennas
LoRa Antennas
GPS&GNSS&IRID Antennas
VHF/UHF Antennas
DVB-T Antennas
RF Cables
Antenna Accessories
RF Connectors
Case
Antenna Application References
Industry News
Blog
Industry news
Media Reports
Contact
PROFESSIONAL ANTENNA MANUFACTURER & ODM/OEM SUPPLIER
Antenna Case
The application of sector antenna
According to the installation position is determined to cover the range of the antenna, the best is the antenna away from the ground more than 10 meters,it can effectively avoid the ground object block,higher install, better effect. Clip the pipe type of the antenna to the pole. Adjust and set the right direction. Connect the connector of the antenna and pay attention to the connection of the joint of the antenna sealed. Loosen the connecting pipe in the middle of the bolt, adjust the tilt Angle of the antenna , set up the correct downward inclination angle, then tighten all the nuts. The transit the energy of the launch restrictions in the arc and narrow vertical within range.Although the absolute range is limited,however, this configuration has a good data rate,And signal well consistency in the coverage area. The signal received is the best.
2020-07-21
Terminal antenna application
Wireless AP antenna can be used in indoor and outdoor bridges equipment, routers and other terminal device.The antenna is designed for Telecommunications application, directly connected to the device,with a high transmission rate, high sensitivity to accept the characteristics,match ith AP bridge equipment to use, it can build a comprehensive WLAN signal coverage system.
Application of UAV antenna
The UAV antenna has the advantages of small volume, light weight, low power consumption, high sensitivity and flexible installation advantages, it can achieve a good broadband impedance, so as to effectively improve the antenna radiation efficiency, improve the antenna gain.The utility model has the advantages of convenient disassembly and assembly, direct and vertical installation at the tail end, and good performance of resistance to damage and three prevention. Based on the whole UAV Device, including UAVs, the UAVs have an insulating bottom shell, insulated bottom shell has the cavity,the inner side of the cavity is equipped with an antenna mechanism, the antenna structure is FPC antenna or LDS antenna.
Yagi antenna application
To confirm the best installation position Based on the cover range of the antenna, the best is the antenna away from the ground more than 3 meters,it can effectively avoid the ground object block and ground reflected wave effect to get the optimal results,higher install, better effect , but do not use it as the lightning rod. To determine the position of the antenna,alignment the coverage of the area that you want, fixed the antenna,let the little tooth of the antenna up, to reach the best effect. You can simple alignment to the cover area and then connect with the pigtail.The antenna with the RF cable itself ,it can be connect directly to the amplifier.
2020-08-13
Get in touch!
Or Enquiry
No waiting—we’re on it in a flash.