To confirm the best installation position Based on the cover range of the antenna, the best is the antenna away from the ground more than 3 meters,it can effectively avoid the ground object block and ground reflected wave effect to get the optimal results,higher install, better effect , but do not use it as the lightning rod.
To determine the position of the antenna,alignment the coverage of the area that you want, fixed the antenna,let the little tooth of the antenna up, to reach the best effect.
You can simple alignment to the cover area and then connect with the pigtail.The antenna with the RF cable itself ,it can be connect directly to the amplifier.
The UAV antenna has the advantages of small volume, light weight, low power consumption, high sensitivity and flexible installation advantages, it can achieve a good broadband impedance, so as to effectively improve the antenna radiation efficiency, improve the antenna gain.The utility model has the advantages of convenient disassembly and assembly, direct and vertical installation at the tail end, and good performance of resistance to damage and three prevention.
Based on the whole UAV Device, including UAVs, the UAVs have an insulating bottom shell, insulated bottom shell has the cavity,the inner side of the cavity is equipped with an antenna mechanism, the antenna structure is FPC antenna or LDS antenna.
Wireless AP antenna can be used in indoor and outdoor bridges equipment, routers and other terminal device.The antenna is designed for Telecommunications application, directly connected to the device,with a high transmission rate, high sensitivity to accept the characteristics,match ith AP bridge equipment to use, it can build a comprehensive WLAN signal coverage system.
According to the installation position is determined to cover the range of the antenna, the best is the antenna away from the ground more than 10 meters,it can effectively avoid the ground object block,higher install, better effect.
Clip the pipe type of the antenna to the pole. Adjust and set the right direction.
Connect the connector of the antenna and pay attention to the connection of the joint of the antenna sealed.
Loosen the connecting pipe in the middle of the bolt, adjust the tilt Angle of the antenna , set up the correct downward inclination angle, then tighten all the nuts.
The transit the energy of the launch restrictions in the arc and narrow vertical within range.Although the absolute range is limited,however, this configuration has a good data rate,And signal well consistency in the coverage area. The signal received is the best.